Hejnar Photo E033 Nodal / Macro Rail Update

Right after the release of my E031 Nodal / Macro Rail review, Hejnar Photo is supplying an updated version of this rail which I present for reference.
The new rail code is E033 and is almost identical to the E031 except for few details and improvements. Major obvious differences are, that it is equipped with a 12mm spirit level and that the captive slot is now 2cm shorter in length following the same design with the E034 rail.

The E033 Rail

Hejnar Photo E033 rail top view. It is obvious that the captive slot had to be  shortened  by 2cm  in order to accommodate the spirit level in the front end of the rail. The scale numbering stops at 11 cm instead of 13 in the E031.
A new improvement is the existence of a fifth pin hole for the alignment of F6nn Quick release clamps which was not present in E31.

Bottom (or back) view that reveals an improvement with two M3 safety stop screws at both ends instead of one in the front on the older version, as well as a recess in the front, where the spirit level is embedded. and a small change in the rear in order to accommodate the fifth pin hole.

Combined with a Clamp

Combined with F012 Quick Release Clamp.

Combined with F62 Quick Release Clamp

I hope you found this presentation useful, thank you for viewing.
All Photos used by permission: © 2011 Chris Hejnar / Hejnar Photo

Availability:
Hejnar Nodal Slides are available from the Hejnar Photo online Store.

If you are interested in the product, do check the Recommended Sellers page for a valid Hejnar Photo discount coupon before ordering.

Referenced Articles:
Hejnar Photo F010A and F012 Quick Release Clamps
Hejnar Photo F62 Quick Release Clamp
Hejnar Photo E031 Nodal/Macro Rail
Hejnar Photo E034 Nodal/Macro Rail